Tank Cleaning Sucks… and So Does Bad Threading | 33
Description
Every machinist knows the two worst kinds of headaches: when your threads don’t come out right, and when it’s time to clean the coolant tank. In this episode, the guys swap shop stories about snapped taps, thread engagement gone wrong, and the endless debate of form tapping vs. cut tapping. Then it’s on to the dirty side of the shop — coolant tanks, chip mess, and the cleanups nobody wants to deal with.
🔔 Subscribe, Rate, and Review to never miss an episode. Your feedback helps us bring you the content you love!
Drop your comments or topic ideas in the forum here:
https://www.practicalmachinist.com/forum/categories/the-impractical-machinists-podcast.102/
Or listen to our podcast on YouTube: https://www.youtube.com/playlist?list=PLxzIM06jyJCYTCMGUQLgKXNtpq-HqvV2Q
Connect with the hosts on Instagram:
Patrick Mcclintock: IG: https://www.instagram.com/job_shopper_tn/ or PM@Job Shopper TN
Cameron Graves: IG: https://www.instagram.com/machiningiscool/ or PM@Machiningiscool
Bradley Thomas: IG: https://www.instagram.com/marvelmachining/ or PM@Marvel
Thanks for listening!!!
United States
